My second semester finished on Friday, and now finally I can get back to updating my blog! Sorry for the severe lack of inactivity here. ._.
This particular project was started back in the first semester, when I had bought a large pack of white paper. I started making 3D units for the heck of it, and then thought it would make a nice swan. I’m made a stick-tailed peacock before and a phoenix, but not a plain old swan, funnily enough!
The general shape of the swan is up to you. For my own, I made the neck longer that the wings. I couldn’t quite shape the wings out well because I was gluing the pieces as I went along; it may be taboo to you, but it’ll hold together much better for me!
Don’t forget the orange and black piece to make the beak of the swan. 🙂
Now obviously, these pots tend to be hollow on the inside. If you want to transform it into a makeshift pot, cut out a circle that is slightly bigger than the very bottom of the base, then slip it through from the top and gently push the sides down to hold it in place.
Of course, this part is totally optional, but sometimes I like a little functionality in my decorations! Now my dear swan holds my pens and pencils for me. And because the wings are so close together, it kind of fans out the pens so it organises my collection pretty well, haha.
Another optional part, because I had a lot of leftover pieces to use up. I connected them all to make a ring for my swan to sit on top of. It’s only purpose really is to keep the base of the swan from pushing down too much. Quite often I’d find that the bottom row of the base tends to look different because it’s been pushed down too much. Well anyway, it just looks nice, haha.
Now just position your lovely swan on top of the ring. The total count of pieces used is 634 units!
Materials: 634 3D units (632 white, 1 orange, 1 black), PVA glue